Graphic Annunciator

General Description

Our Graphic Annunciator, the LD series, is housed in a sturdy brushed aluminum frame and attached to its back box with a vandal resistant “hidden” hinge. It is key lockable to prevent unauthorized access.

Each LD series annunciator can be customized to accommodate most any lamp driver module you can provide. It can accept anything from the LDM-32 by Notifier to the SIM-16 by Siemens and almost anything in-between. We interface your lamp driver module with our door though factory installed and wired circuit boards.

A Green LED will indicate that the annunciator is properly powered and in standby. All units come standard with a lamp test, most commonly a push button switch. When activated, ALL system indicators should light as a demonstration that all internal circuits, wiring and LED’s are functioning properly.

Terminal strips, mounted inside the door, facilitate the wiring of Field Devices. Screw connectors are complete with captive wire protection and are automatically secured against loosening.

PDF Download

Features

Non glare protective front
Low power consumption
Ultra Bright Light Emitting Diodes Lamp Test – Standard
Per Point Diode Isolation on all inputs Intended for indoor / dry location

Technical Specifications

Standby Voltage: Nominal 24 Vdc: Min. 18 Vdc to 36 Vdc
Standby Current: Typical Range 0 -15 ma
Alarm: Approx. 15 ma for each Activated LED (max input @ 3 Amps)
Indicators: Super Bright LED’s – Red, Amber and Green
Activating Voltage: Positive or Negative as specified by customer
Operating Temperature: 32-100F (0-38C)

Engineer Specification

The contractor shall furnish, where indicated on the plans, a U.L. Listed Graphic Annunciator Panel.

Standard features shall include but not be limited to: Built-In Voltage Regulation, Reverse Polarity Protection, Per Point Diode Isolation and a Lamp Test Switch. Additionally, the unit shall be capable of lighting all its indicators simultaneously.

The Annunciator shall be (Back-lit, Front-lit). Unit shall be (Semi-flushed mounted, Surface mounted). Assembly shall be of “Dead-Front” construction, with no exposed screws or hinge. Artwork and indicators to be protected by a sheet of Non-glare Plexiglass, finished with a brushed Aluminum frame.

Annunciator shall be able to operate from a nominal 24 Volts D.C. supplied by the Main Fire Alarm Panel. Unit will utilize the Fire Alarm Panel’s standby batteries during loss of normal power.

Upon activation of any Alarm initiating device, the annunciator shall geographically display the location of the device in alarm.

The Annunciator shall be manufactured by Light Engineered Displays, Inc., or approved equal.

Ordering Information

Graphic sizes are shown below, according to model number

Please Contact Us for ordering! *

*A drawing is required showing the actual graphic representation needed for your project. The exact location of the indicator points should be shown and identified by a legend. Mark the Annunciator location on the plans so that the artwork can be oriented properly with a “You Are Here” designation.

**The maximum area available for artwork is the outside dimension, less two inches. We will work from your blueline, copy, fax, sketch, email or CAD file. Please note: a full size, inked mylar, from your CAD drawing, will speed production.

Note: For Semi-flush mounting, add 3” to overall “W” and “H” dimensions. Consult the factory regarding custom sizes, products, options or special requirements.